800.596.7472


 
 

6610DT Geoprobe

  • 66 in. (1676 mm) probe cylinder stroke allows use of 60 in. (1,524 mm) probe rods
  • Over 20 ton pulling capacity for today’s larger sampling tools and deeper depths
  • Equipped with the powerful GH62 Hammer
  • Narrow 48" Undercarriage allows this powerful, well-equiped machine to access locations impossible to reach with standard equipment.
  • Wireless remote control
  • Built-in rotary spindle for concrete drilling, augering, and anchoring
  • Equipped with a hydraulic winch for handling augers and tripping dual tube sampling tools
  • Two-speed probe cylinder cycles from bottom to top in less than 5 seconds
  • Powered by a four-cylinder, 54 Hp, liquid-cooled Kubota turbo diesel engine
  • Hydraulic movement in all three axes allows easy probe alignment with tool string
  • Auxiliary hydraulic ports provide power for remote equipment

    The design of the Geoprobe® Model 6610DT direct push machine offers the complete package. From auxiliary power sources, a workhorse hammer, and a well-planned work area. The tracks allows this direct push machine to be used on concrete and pavement as well as off-road and rugged terrain. The width of the machine is 48 inches with the narrow undercarriage providing excellent access to tight locations for probing and drilling. The machine is equipped with augering capabilities, a winch to help with tool placement, and a DH100 Auto Drop Hammer. The 6610DT Geoprobe can flexibly switch from environmental to geotechnical work with little time and effort. The Geoprobe DH100 Auto Drop Hammer allows the collection of Standard Penetration Test (SPT) data which conforms to ASTM D1586-99. The machine also includes a wireless remote control, onboard tool storage, and an accessible engine compartment for quick systems checks.

    Water Transport System provides 25 gallons of water in a polyethylene water tank.

    Overhead Mast and Hydraulic Winch aids in heavy lifting of large tooling and augers. Also helpful for tripping dual tube samplers. Lifting capacity is approximately 3,000 pounds.

    GA3000 Augerhead swings out from mount enabling 5 minutes changes from direct push. Capable of holes from 2.5 in to 9.75 in OD.

    DH100 Automatic Drop Hammer allows geotechnical standard penetration tests. Uses auxiliary hydraulics on machine for repeatable and accurate blow count results.

  • Geoprobe 6610DT specifications
     
    Support for Internet Explorer prior to IE9 is minimal. Portions of this site may display erratically. Upgrade your browser.